ここから本文です
TWO:"There, chicken-hearted carle!" cried the smith, felling Kirkby to the ground with his mailed hand"there, dog!Wat Tyler must be obeyed! And now, Simon Sudbury, take off that blessed mitre, which ill befits thee, and come forth; for, by my faith and the blessed St. Nicholas! in one hour hence, thy head shall be stuck on London bridge, wrapped up in the hood of thy own mantle!" And with this, Tyler placed his foot on the first step of the altar."And does your abbot think, when the hope of my house has perished, whether by false incantations or deadly poison, thatDepart, monk!" continued he, in a choked voice, "and tell your abbot that this woman's guilt or innocence shall be tried by the laws of the realm."
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:It was uninhabited, but the door was fastened, and Holgrave forcing it open, led the way into the deserted abode. A chill came over him as he removed the chest; but taking up a shovel from a corner, where he himself had thrown it, he prepared to remove the clay. He hesitated for a moment, and then began his task;he had dug about a foot deep, when, raising up a slip of wood about one foot broad and two in length, the perfect form of an infant, lying beneath, caused those who were looking silently on to utter an exclamation.

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:These things, however, gave little concern to the worthy who commanded the Kentish division. Tyler, though an excellent blacksmith, possessed few of the qualities requisite for forming a good general. Provided there was no very sensible diminution in the number of his followers, he cared not a straw for the score or two who, after quarrelling, or perhaps fighting, withdrew in such disgust that they vowed rather to pay the full tax for ever than submit to the insolence of the rebels. One man could fight as well as another, reasoned he; and, provided he was obeyed, what mattered it by whom. Dick went and Tom cameit was sure to be all one in the end.
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:Chapter 8

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:"Stopyou're spoiling my h?adge!"
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.